How to Fix a Washing Machine That Smells Like Sewer

A washing machine that smells like sewage usually has a drainage issue, trapped debris, or a bacterial buildup inside the drum, gasket, or drain components. The odor is typically caused by stagnant water, organic matter, or sewer gas escaping back into the appliance rather than being flushed away properly. Identifying where the smell originates and correcting the underlying problem will eliminate the odor and prevent it from returning.

This guide covers the most common causes of sewer smells in washing machines and provides step-by-step instructions to fix them, from simple cleaning methods to plumbing inspections.

Common Causes of Sewer Smells in Washing Machines

Before cleaning or repairing the machine, it helps to understand what is likely causing the odor. Sewer-like smells generally fall into a few categories:

  • Drain hose issues: A missing or improperly installed drain hose standpipe allows sewer gases to travel back into the machine.
  • Clogged drain pump filter: Lint, hair, soap residue, and small objects can collect in the filter and rot, producing a foul smell.
  • Standing water: Water left in the drum, hoses, or pump after a cycle creates a breeding ground for bacteria and mold.
  • Dirty door gasket (front-loaders): Moisture and detergent residue trapped in the rubber seal can develop a musty, sewage-like odor.
  • Clogged standpipe or household drain: A slow drain in the laundry sink or standpipe can cause water to back up and emit sewer gas.

Step 1: Run a Cleaning Cycle

Start by cleaning the interior drum and plumbing components to remove bacteria, soap scum, and mildew. This is often enough to eliminate mild to moderate odors.

  1. Empty the washing machine completely.
  2. Select the hottest water setting available, or use a dedicated “Clean Washer” cycle if your machine has one.
  3. Add two cups of white distilled vinegar directly to the drum, or use a commercial washing machine cleaner according to the package directions.
  4. Run the full cycle without any clothing.
  5. If the smell persists, repeat the cycle using half a cup of baking soda in place of vinegar, or run a second hot cycle with bleach if your manufacturer permits it.

After the cycle finishes, leave the door or lid open for several hours to let the interior dry completely. Front-load machines in particular benefit from air drying to prevent moisture from lingering in the door seal.

Step 2: Clean the Door Gasket and Detergent Drawer

Front-load washing machines commonly trap water and residue in the rubber door gasket. Pull the gasket back gently and inspect for mildew, hair, or debris. Wipe the area with a damp cloth and a mixture of equal parts white vinegar and water. For stubborn buildup, use a soft brush or an old toothbrush.

Remove the detergent dispenser drawer if your model allows it. Scrub it with warm water and a brush to remove dried detergent and fabric softener residue, then dry it thoroughly before reinstalling. These areas can harbor odor-causing bacteria even when the drum itself is clean.

Step 3: Inspect and Clean the Drain Pump Filter

Most front-load washers and some top-load models have an accessible drain pump filter located behind a small panel near the bottom front of the machine. This filter catches lint, coins, hair, and other debris that can rot and smell like sewage.

  1. Unplug the washing machine and turn off the water supply.
  2. Place a shallow pan and several towels under the filter access panel, as water will drain out when you open it.
  3. Open the panel and slowly unscrew the drain pump filter cap.
  4. Allow all water to drain completely, then remove the filter.
  5. Rinse the filter under running water and use a soft brush to clear any debris.
  6. Inspect the filter housing for additional blockages before reinstalling the filter and cap securely.

If your machine is a top-loader without an accessible front filter, skip to the drain hose inspection below.

Step 4: Check the Drain Hose and Standpipe

The drain hose carries wastewater out of the machine and into your home’s plumbing. If the hose is kinked, clogged, or installed too far into the standpipe, water can stagnate or sewer gas can back up into the washer.

  1. Unplug the machine and pull it away from the wall to access the drain hose.
  2. Inspect the hose for kinks, clogs, or damage. Straighten any bends and clear obstructions if possible.
  3. Check how far the hose extends into the standpipe. It should not be pushed more than about 4 to 6 inches inside. If it is inserted too deeply, it can create a siphon effect or block proper air flow, allowing sewer gas to enter.
  4. Ensure the standpipe itself is at the correct height, usually between 18 and 36 inches above the floor, depending on your machine’s manual.
  5. If the hose connects to a laundry sink tailpiece or garbage disposal, confirm that the connection is secure and that the sink drain is not clogged.

Run a short rinse and spin cycle after reconnecting everything to confirm that water drains quickly and completely.

Step 5: Use an Enzyme Cleaner or Baking Soda Treatment

If the odor remains after mechanical cleaning, an enzyme-based drain cleaner can break down organic buildup inside the drain hose and standpipe. Pour the cleaner into the drain according to the product instructions, let it sit for the recommended time, then flush with hot water.

Alternatively, run an empty hot cycle with one cup of baking soda followed by one cup of white vinegar. Let the mixture sit in the drum and drain system for 30 minutes, then complete the cycle. Avoid combining bleach with vinegar or other cleaners, as this can produce dangerous fumes.

When to Call a Plumber

If you have cleaned the machine, checked the filter, and inspected the drain hose but the sewer smell persists, the issue may be in your home’s plumbing rather than the appliance. A plumber can inspect the standpipe trap, main drain line, or vent stack for clogs, dry traps, or improper venting that allows sewer gas to enter the laundry area.

Call a professional if you notice water backing up into the washer or laundry sink, gurgling sounds from the drain, or if multiple fixtures in your home are draining slowly.

Preventing Future Odors

  • Leave the washer door or lid open after each use to allow the interior to dry.
  • Wipe the door gasket weekly on front-load machines.
  • Clean the detergent drawer monthly.
  • Inspect and clean the drain pump filter every few months, or as recommended by your manufacturer.
  • Use the correct amount of high-efficiency (HE) detergent to reduce excess suds and residue.
  • Run a monthly cleaning cycle with vinegar or a washing machine cleaner.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *